Volume 1

November 2014, Volume 1, Number 3

A Study of Crankpin Failure in I.C. Engine
M. Senthil kumar1, S.Ragunathan2, M.Suresh1 and V.R.Srinivashan2, 1Sona College of Technology, India and 2Jayalakshmi
Institute of Technology, India

Micro Planning And CNC Programming For Cylindrical Part In AMPPS
Shinde B.M1 and Khodke P.M2, 1Dnyanganga College of Engineering & Research, India and 2Government College
of Engineering, India

August 2014, Volume 1, Number 2

Analytical Solution for the Temperature Distribution in Cross-Flow Plate Heat Exchanger Channels of Isosceles
Triangular Geometry

Rilrada Sangsawang, Thanate Matum and Udomkiat Nontakaew, King Mongkut's University of Technology
North Bangkok, Thailand

Performance Analysis of a Combined Cycle Gas Turbine under Varying Operating Conditions
Dillip Kumar Mohanty and Vijay Venkatesh, Birla Institute of Technology & Science, India

A Methodology for Analysis of Topological Charateristics of Planetary Gear Trains
S.R.Madan, Sajid Quresh and Mustaq Ptel, Mahakal Institute of Technology and Management, India

Investigation of Spring Back Behavior of SS-304 Steel and its Bi-Layer Material in V Bending
Chintan K. Patel, C.K.Pithawala College of Engineering & Technology, India

May 2014, Volume 1, Number 1

Three-Dimensional Study for the Relative Positioning of Mechanical Elements in Mechanisms Constituted by Parallel
Joints with Clearances

Mohamad Younes1, Philippe Dal Santo2 and Alain. Potiron2, 1Lebanese University, Lebanon and 2Ecole Nationale
Supérieure d'Arts et Métiers France

Delamination Behaviour and Experimental Validation of Glass Fabric/Epoxy
Matrix and Carbon Fabric/Epoxy Composites in Mode-1 Loading

R.Hemanth and B.Naresh, Vellore Institute of Technology, India

Production Process Analysis on Manufacturing of Hydraulic Gear Pump
J.J.Kathiriya1, V.D.Amareliya2 and S.H.Kapadiya2, 1Shantilal Shah Engineering College, India and 2Gandhi Institute
of Technical Education and Research Centre, India

Analysis and Study the Effects of various Control Factors Of Cnc-Wire Cut Edm for S7 Steel
SonuDhiman, RavinderChaudhary and V.K.Pandey,Shri Krishan Institute Of Engineering & Technology, India